VeroCAD-Vi | |||
Samples of board configurations
For information on Prototyping or Prototyping with VeroCAD click here
|
|||
|
|||
Prototyping with VeroCAD: The use of Veroboard™ for prototyping circuits is common among hobbyists and professionals. One common method used is called "best guess", this method is to position the components on the board then rearrange each or all until the best position is found. "best guess" is extremely time consuming and prone to error. VeroCAD addresses this issue by allowing the builder to visually layout the board and reposition components with a click of a button. So what did take 3 hours can now be achieved in 3 minutes. When the design is complete the layout can be printed to a label, this label is then attached to the perf-board and used as the hole and component locator. Not only can the board be laid out in a fraction of the time, it can also be assembled quickly and accurately. VeroCAD-Vi includes a selection of built-in proto-board layouts as well as board editor allowing the user to create new boards or change existing designs. |
|||
Copyright (C) 2004 - 2022 Wings of Technology - All rights reserved
|